JEFFERSON COUNTY FAIR, TN

Little Car and Powder Puff Rules

Derby

INSPECTION 4PM – 7PM , DERBY STARTS 7:30PM
ENTRY FEE $45.00(NON REFUNDABLE)

GENERAL
  1. Any 4 OR 6 cylinder FWD car. You may run 4 cylinder RWD cars, NO MINIVANS ALLOWED.
  2. Helmet, eye protection, and working seat beld are mandatory
  3. Must have working brakes
  4. If parts are changed in between heat, consultation, or main, they must still be in accordance to the rules or you will be disqualified
  5. If you fail inspection for the 2nd time, you will repay entry fee if you want another shot
BODY
  1. All glass, trim and interior should be removed with the exception of the driver seat
  2. Must have factory body bolts and bushings in all locations
  3. Rear quarters and pillars can be creased, but must remain upright, no doubling or seam welding, can shape the truck
  4. Hoods and trunks must have a hold 10” X 10” for inspection and hoods must be open during inspection
  5. Doors and trunks may be secured by unlimited wire, chain or welded with 3” X 3″ plates 2 per seam, cannot combine any of the options
  6. Driver’s door can have door plate ¼”; max not to exceed the door seams and driver’s door only can be welded solid
  7. Hoods can be secured by wire, chain, or 3 pieces of angle no longer than 3” with a bolt, 3 per each side will be allowed
FRAME
  1. No welding of any kind on the frame unless stated in the rules
  2. You may notch the frame behind the rear axle
  3. Prerun cars will be allowed a total of 2- 3X3X1/4” Plates
  4. Camry guys, frames will be drilled and checked!!
STEERING AND SUSPENSION
  1. Stock suspension only with no modifications
  2. Can run aftermarket steering
DRIVETRAIN
  1. Can weld motor mounts
  2. No engine cradles or protectors of any kind
  3. Can run aftermarket shifter, pedals
  4. Can run any wheel and tire combo
DRIVERS COMPARTMENT
  1. Can have 4 point cage with 60″ max door bars
  2. Cage must be 1″ from firewall and 6″ from floor
  3. NO gas tank protectors
  4. Cage can attach to sides only, no down bars of any kind
  5. Rollover bar is optional, can only attach to cage and must be straight up and down
  6. Battery and fuel tank must be secured and covered
  7. If the fuel tank is in front of the rear axle, it can be left in its original position
  8. If using electric fuel pump, must have kill switch marked for emergency personnel
BUMPERS
  1. Can use any bumper, if homemade can’t be any thicker than ¼”. No extreme points or you cut it off
  2. Bumpers can be seam welded and loaded
  3. Factory bumper shocks only and can be welded to frame and bumper. Must be extended 2”, no added metal of any kind, can hardnose bumper
  4. Must wire or chain bumpers.
  5. Bumpers can be no lower than 16” and no higher than 24” measured from the bottom


IF YOU BUILD IN THE GRAY AREAS BE PREPARED TO TO CUT OR WATCH FORM THE STANDS. IGNORANCE OF THE RULES IS NO EXCUSE!!!
THE FOLLOWING WILL RESULT IN IMMEDIATE DISQUALIFICATION:

  1. BREACHING OF THE OUTSIDE BARRIER
  2. IGNORING ANY OFFICIAL
  3. NON COMPLIANCE WITH THE RULES
  4. USE OF ANY ALCOHOL OR DRUGS
  5. TARGETING A DRIVERS DOOR
  6. FIGHTING AND THIS INCLUDES YOUR PIT PEOPLE
  7. 2ND FIRE
  8. TAG TEAMING OR SANDBAGGING

ANY QUESTIONS, TEXT GARY ROBINSON BEFORE 9PM 865-603-9390

PAYOUTS FOR THE TOP 5
13 CARS OR LESS14-19 CARS20 OR MOREPOWDER PUFF
1-$10001-$15001-$20001-$500
2-$5002-$5002-$7002-$300
3-$3003-$3003-$5003-$200